After reading the article I had no more idea of what this Synchronous technology is than I did before reading it. This is not just with this article but all the articles that I have seen and read from many sources. What would have been more informative would have been an article that gives some of the meat and potatoes of this technology and how it is going to increase the designer's efficiency. How about some examples with actual pictures and demos on how it is different than what is out there today. To anyone who is continuing to write about this evolutionary change in working with CAD, until you can provide ACTUAL examples, all you are doing is increasing the HYPE. How about some hard facts. Until then I will continue to use my Ironcad as it seems to have all this stuff already.